...
| Info |
|---|
The ReFlex system must be connected to the PT-CAN2 network and configured to communicate over one of the following CAN ID 0x334bus IDs: 0x334, 0x00EC, or 0x04CB. |
If you find unexpected data being logged from the ReFlex, there may be a CAN bus ID conflict. Consider trying an alternative ID. This can commonly be observed by an unexpected MGF limp mode if you have protection mode enabled and a low pressure fuel pressure sensor installed.
Initial support
MG Flasher has added the ability to log various parameters from the ReFlex module directly in the MG Flasher app with the latest Custom Code (v7.2+):
...