Tip |
---|
Custom Code v6.9.2 has been released with App version 326! This update brings cruise control and BC button functions to Switchable Maps, Burbles, Max Cooling, and Antilag On-The-Fly (while the car is in motion)! |
...
Expand | ||||||
---|---|---|---|---|---|---|
| ||||||
There is a ~10 second timeout which will cancel your selection if no buttons are pressed. If the selection menu times out, the map slot will not be adjusted and no changes will be saved. |
Expand | ||||
---|---|---|---|---|
| ||||
Driver Experience Switch and MSA Button.
In case your BMW does not have SPORT+ mode you will be limited to Slot #1, #2, #3 and reverting to Slot #0 is possible from SPORT mode by the same sequence - SPORT and 2 quick MSA presses Within the 5 seconds of holding the Gas Pedal at W.O.T position (while still holding the Brake Pedal) you will notice the RPM on the dash will reflect the choice you have selected (ie. 3000 RPM = Slot #3). Release the Brake and Gas Pedals fully to exit the selection process. RPM on the dash will return to actual engine RPM and the Check Engine Light will stop blinking. Now you can enjoy your newly selected map-set! |
Gen 1 F-Series B48 Hybrid Information
Expand | ||
---|---|---|
| ||
B48 Hybrid OTS maps require Custom Code v7.0 or newer. Stage 1 - Custom Code v7.0+ Stage 2 - Custom Code v7.0+ |
Gen 1 F-Series B48 (Non-Hybrid) Information
We added stock power levels to which you can immediately switch, 184 bhp or 252 bhp, depending on the car and 252 bhp.
Expand | ||
---|---|---|
| ||
Stage 1 - Custom Code v6.0 Stage 2 - Custom Code v6.0 |
...
Expand | ||
---|---|---|
| ||
Stage 1 - Custom Code v6.0+ Stage 2 - Custom Code v6.0+ High Pressure Fuel Pump (HPFP) Required for Stage 2.5 (slot #2) and highly recommended for Ethanol maps (E30 slot #3) Stage 2.5 - Custom Code v6.0+ High Pressure Fuel Pump (HPFP) Required |
...
Switchable map can only be achieved under the following conditions:
Switchable maps must be available and enabled in your software (selected during flashing process). Currently, only available on F-Series Gen 1 B46/B48/B58 (non hybrids). G series will be available soon.
Engine must be running (more than 30 seconds from start when using Custom Code v5.4 and earlier, Custom Code v6.0 can be used as soon as engine starts)
(Custom Code v5.4 and earlier) Vehicle must be at a standstill.
For users with Custom Tunes, please refer to the information on this page to gain access to this feature:
Custom Tuners - Map Pack Guide CC v6.9
Video (Outdated)
Watch our instructional video on YouTube to see how it works and read below for more info!
...