Versions Compared

Version Old Version 5 New Version Current
Changes made by

Szymon

Szymon

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Note

If you have Custom code v7.0.x or older, see instructions here: [Outdated] Configure Antilag (Launch Control) Before Custom Code v7.1

  1. Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly.

    Custom Code Menu details can be found here: [WIP] Custom Code Menu (CCM)

OR

OR

  1. Move rocker up and down to navigate through the Custom Code Menu until you reach 4000 RPM (the Antilag submenu).

Info

UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.

  1. Using your button configuration, press “enter” to continue into the Antilag submenu.

Info

UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.

  1. Once entered, the Check Engine Light (CEL) will blink 4 times showing you have entered into the Antilag submenu.

  1. Configure launch RPM as desired, by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer. You can hold up/down to adjust the value more quickly

Info

UniRocker: far up/down on the rocker to adjust values. RockerCombo: uses short up/down.

OR

  1. Using your button configuration, press “enter” to accept the displayed RPM setpoint.

Info

UniRocker: hold short up/down on the rocker to accept. RockerCombo: hold BC or RES button.

OR

...