Page Comparison

...

Info
Details about Exhaust Flap On-The-Fly can be found in the main article::Exhaust Flap On-The-Fly

Selecting an Exhaust Flap State

Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly.
Custom Code Menu details can be found here: Custom Code Menu (CCM)

Image Added

OR

Image Added

OR

Image Added

Move rocker up and down to navigate through the Custom Code Menu until you reach 6000 RPM (the Burbles submenu).

Info
UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.

Image Added

Using your button configuration, press “enter” to continue into the Burbles submenu.

Info
UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.

Once entered, the Check Engine Light (CEL) will blink 6 times showing you have entered into the Exhaust Flap submenu.

Image Added

Select the exhaust flap status you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer.

Info
UniRocker: far up/down on the rocker to adjust values. RockerCombo: uses short up/down.

0 RPM - OEM

1000 RPM - Closed

2000 RPM - Open

Image Added

OR

Image Added

Using your button configuration, press “enter” to accept the exhaust flap status.

Info
UniRocker: hold short up/down on the rocker to accept. RockerCombo: hold BC or RES button.

Image Added

OR

Image Added

Exhaust flap will be controlled by the ECU as intended by the manufacturer.

Image Added

Exhaust flap will fully close. However, if the load limiter is exceeded, it will open.

Image Added

Exhaust flap will fully open.

Image Added