Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Current »

Details about Burbles On-The-Fly can be found in the main article: Burbles On-The-Fly

If you have Custom code v7.0.x or older, see instructions here: [Outdated] Configure Burbles On-The-Fly Before Custom Code v7.1

Selecting a Burble slot/level

  1. Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly.

    Custom Code Menu details can be found here: [WIP] Custom Code Menu (CCM)

OR

OR

  1. Move rocker up and down to navigate through the Custom Code Menu until you reach 2000 RPM (the Burbles submenu).

UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.

  1. Using your button configuration, press “enter” to continue into the Burbles submenu.

UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.

  1. Once entered, the Check Engine Light (CEL) will blink 2 times showing you have entered into the Burbles submenu.

  1. Select the burble slot/level you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer.

UniRocker: far up/down on the rocker to adjust values. RockerCombo: uses short up/down.

0 RPM - Slot 0, OEM

1000 RPM - Slot 1, App Slider

2000 RPM - Slot 2, Level 1

3000 RPM - Slot 3, Level 2

4000 RPM - Slot 4, Level 3

5000 RPM - Slot 5, Burble OFF

OR

  1. Using your button configuration, press “enter” to accept the burble slot/level.

UniRocker: hold short up/down on the rocker to accept. RockerCombo: hold BC or RES button.

OR

  • No labels

MG Flasher @ 2024