Using Burbles On-The-Fly

Details about Burbles On-The-Fly can be found in the main article: Burbles On-The-Fly

If you have Custom code v7.0.x or older, see instructions here: [Outdated] Configure Burbles On-The-Fly Before Custom Code v7.1

Selecting a Burble slot/level

Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly. Custom Code Menu details can be found here: [WIP] Custom Code Menu (CCM)	OR OR
Move rocker up and down to navigate through the Custom Code Menu until you reach 2000 RPM (the Burbles submenu). UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.
Using your button configuration, press “enter” to continue into the Burbles submenu. UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.
Once entered, the Check Engine Light (CEL) will blink 2 times showing you have entered into the Burbles submenu.
Select the burble slot/level you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer. UniRocker: far up/down on the rocker to adjust values. RockerCombo: uses short up/down. 0 RPM - Slot 0, OEM 1000 RPM - Slot 1, App Slider 2000 RPM - Slot 2, Level 1 3000 RPM - Slot 3, Level 2 4000 RPM - Slot 4, Level 3 5000 RPM - Slot 5, Burble OFF	OR
Using your button configuration, press “enter” to accept the burble slot/level. UniRocker: hold short up/down on the rocker to accept. RockerCombo: hold BC or RES button.	OR