Using Switchable Maps On-The-Fly

Owned by Szymon
Last updated: Jul 08, 2024
3 min read

Details about Switchable Maps On-The-Fly can be found in the main article: Switchable Maps On-The-Fly

If you have Custom code v7.0.x or older, see instructions here: [Outdated] Configure Switchable Maps On-The-Fly Before Custom Code v7.1

Invalid map slots (those with unpopulated maps) will be indicated with a brief tachometer gauge sweep to 7k RPM when selected. Contact your tuner to ensure that all of the maps in that slot have valid mapping values.

Selecting a Switchable Maps slot

  1. Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly.

    Custom Code Menu details can be found here: Custom Code Menu (CCM)

 

(UniRocker) Short up on rocker
(UniRocker) Short down on rocker

OR

OR

 

  1. Move rocker up and down to navigate through the Custom Code Menu until you reach 1000 RPM (the Switchable Map submenu).

  1. Using your button configuration, press “enter” to continue into the Switchable Map submenu.

 

  1. Once entered, the Check Engine Light (CEL) will blink 1 times showing you have entered into the Switchable Map submenu.

 

  1. Select the Switchable Map slot you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer.

 

0 RPM - Slot 0, OEM map locations

1000 RPM - Slot 1, Custom map location

2000 RPM - Slot 2, Custom map location

3000 RPM - Slot 3, Custom map location

4000 RPM - Slot 4, Custom map location

OR

  1. Using your button configuration, press “enter” to accept the Switchable Map slot.

 

OR

 

MG Flasher @ 2024