...
| Note |
|---|
If you have Custom Code v7.1 or newer, see updated instructions here: [WIP] Antilag (Launch Control) Usage |
...
Adjusting launch RPM for stationary Antilag
Stop the vehicle (below speed threshold to detect rolling)
...
.
Hold SHORT DOWN (first click downward) on the rocker
...
Engine light will blink rapidly. Don’t let go until the last step!
...
...
While still holding far down on the rocker, press the throttle pedal to have ignition cut, timing retarded and to start building boost . Pedal position for activation, timing aggression, and target boost can be adjusted in-app during flashing.
...
Release the rocker switch when ready to launch (sit back first!).
...
Adjusting launch RPM for stationary Antilag
Hold down RES or BC Button to enter Menu. Let go once Check Engine Light starts blinking.
...
OR
...
...
Move rocker up and down to navigate through the Custom Code Menu until you reach 4000 RPM (the Antilag submenu).
...
Press RES or BC Button to enter into the Antilag submenu.
...
Once entered, the Check Engine Light (CEL) will blink 4 times showing you have entered into the Antilag submenu.
...
...
for 2 seconds (engine light will blink) to enter the RPM setpoint configuration mode. This value is defaulted to mapped value (RPM setpoint) if you restart the car.
Tap or hold SHORT UP/DOWN (first click up/downward) on the rocker to increase/decrease the RPM shown on the tachometer.
...
OR
...
Press RESUME or BC button to accept the setting displayed RPM setpoint.
...
OR
...