[Outdated] Configure Antilag Before Custom Code v7.1

Owned by Szymon
Last updated: Oct 04, 2023
1 min read

Details about antilag can be found in the main article: Antilag (Launch Control)

If you have Custom Code v7.1 or newer, see updated instructions here: Using Antilag

Adjusting launch RPM for stationary Antilag

  1. Stop the vehicle (below speed threshold to detect rolling).

  2. Hold SHORT DOWN (first click downward) on the rocker for 2 seconds (engine light will blink) to enter the RPM setpoint configuration mode. This value is defaulted to mapped value (RPM setpoint) if you restart the car.

  3. Tap or hold SHORT UP/DOWN (first click up/downward) on the rocker to increase/decrease the RPM shown on the tachometer.

  4. Press RESUME or BC button to accept the setting displayed RPM setpoint.

MG Flasher @ 2024