1. Requirements
...
To ensure your hardware is properly configured follow the instructions in this section. The first thing you may notice on your Android screen is a notification of MG Flasher requesting permission to access your connected peripheral. You must accept these requests for MG Flasher to connect to your vehicle.
...
Accept permission request to grant MG Flasher access to your peripheral.
...
Info |
---|
Tap to enable Ethernet, click "Configure Ethernet device", select "Static IP" and enter the IP addresses above. Save. |
Note |
---|
When car was previously connected to other device please wait until the car goes to sleep mode or reset the FEM module manually. After couple of minutes please make the connection attempt with your phone. Some Android 13+ phones have problems with setting the static IP configuration using the configuration above. Please ensure your device have installed all software updates provided by manufacturer first. |
3. Connections
Let’s review how to connect your newly purchased hardware to your smart device and BMW.
...