Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Details about antilag can be found in the main article: Antilag (Launch Control)

If you have Custom Code v7.1 or newer, see updated instructions here: [WIP] Antilag (Launch Control) Usage

Stationary How to get into menu:

  1. Hold down RES or BC Button to enter Menu. Let go once Check Engine Light starts blinking.

OR

  1. Move rocker up and down to navigate through the menu until hitting 4000 RPM.

  2. Press RES or BC Button to enter into 4000 RPM for Antilag.

  1. Once entered into 4000 RPM the Check Engine Light will blink 4 times showing you have entered into Antilag.

  1. Configure launch RPM to min amount.

  1. Tap or hold SHORT UP/DOWN (first click up/downward) on the rocker to increase/decrease the RPM shown on the tachometer.

OR

  1. Press RESUME or BC button to accept the setting displayed RPM setpoint.

OR

Stationary Antilag On-The-Fly Configuration

To change the launch RPM for Stationary Antilag:

  1. Stop the vehicle (below speed threshold to detect rolling).

  2. Hold SHORT DOWN (first click downward) on the rocker for 2 seconds (engine light will blink) to enter the RPM setpoint configuration mode. This value is defaulted to mapped value (RPM setpoint) if you restart the car.

  1. Tap or hold SHORT UP/DOWN (first click up/downward) on the rocker to increase/decrease the RPM shown on the tachometer.

OR

  1. Press RESUME or BC button to accept the setting displayed RPM setpoint.

  • No labels

MG Flasher @ 2024