Page Comparison

CCM will use the cruise control buttons to navigate the menu and make/confirm selections.

The RES button is used to enter the CCM, submenus, and confirm selections.

The rocker is used to change selections, increase/decrease values for settings, activate Antilag (Antilag (Launch Control)) or activate Ethanol Content Display ([WIP] Ethanol Content Display ).

The rocker button has 5 distinct positions (shown in an animation to the right):

• Far up

• Short up

• Center

• Short down

• Far down

CCM will use the turn signal stalk to navigate the menu and make/confirm selections.

These are not used with Custom Code Menu.

Each thousand of RPM will be a selection for the CCM. Entering the selection will proceed into the sub-menu.

0k RPM - Exit the Custom Code Menu

1k RPM- Switchable Maps On-The-Fly

2k RPM - Burbles On-The-Fly

3k RPM - Max Cooling On-The-Fly

4k RPM - Antilag (Launch Control)

5k RPM - [WIP] Ethanol Content Override

6k RPM - [WIP] Exhaust Flap On-The-Fly

7k RPM - [WIP] Using Valet Mode On-The-Fly

Counted blinks indicate which submenu is active. The CEL will blink the same number of times as the given Custom Code feature’s tachometer value (7 thousand RPM = 7 blinks). On the right, you’ll find 3 examples: 1 blink indicating you’re in the Switchable Map submenu, 3 blinks indicating the Max Cooling submenu and finally 7 blinks indicating the Valet Mode submenu.

• 1 Blink - Switchable Maps On-The-Fly

• 2 Blinks - Burbles On-The-Fly

• 3 Blinks - Max Cooling On-The-Fly

• 4 Blinks - Antilag (Launch Control)

• 5 Blinks - [WIP] Ethanol Content Override

• 6 Blinks - [WIP] Exhaust Flap On-The-Fly

• 7 Blinks - [WIP] Valet Mode On-The-Fly

With the [WIP] RockerCombo button configuration:

• The menu can be opened by holding either the RES button (on the Cruise Control, Section A) or the BC button (on the Turn Signal Stalk, Section C) for a few seconds.

With the [WIP] UniRocker button configuration:

• The menu can be opened by holding either the short up or short down rocker button (on the Cruise Control, Section A) for a few seconds.

The amount of time the button must be held can be adjusted in app when flashing; this option is called Delay to Enter Menu under the “Custom Code Menu” settings on the “Custom Options” flashing page.

When using [WIP] UniRocker:

When using [WIP] RockerCombo:

OR

Once in the Custom Code Menu, users can briefly press the BC or RES buttons (with [WIP] RockerCombo) or hold the short up/down rocker button (with [WIP] UniRocker) to navigate into a submenu.

For [WIP] UniRocker:

The amount of time the button must be held can be adjusted in app when flashing; this option is called UniRocker enter button delay under the “Custom Code Menu” settings on the “Custom Options” flashing page.

When using [WIP] UniRocker:

When using [WIP] RockerCombo:

OR

Once within a submenu such as Switchable Maps On-The-Fly or Burbles On-The-Fly, move the tachometer using the rocker buttons (short up/down for [WIP] RockerCombo or far up/down for [WIP] UniRocker) to select a value.