Using Valet Mode On-The-Fly

Details about Valet Mode On-The-Fly can be found in the main article: Valet Mode On-The-Fly

Vehicle's ignition needs to be on.

When one of the limits have been exceeded in valet mode, the check engine light starts blinking and stays on until valet is turned off.

Enable or Disable Valet Mode

Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly. Custom Code Menu details can be found here: Custom Code Menu (CCM)	(UniRocker) Short up on rocker (UniRocker) Short down on rocker OR OR
Move rocker up and down to navigate through the Custom Code Menu until you reach 7000 RPM (the Valet Mode submenu).
Using your button configuration, press “enter” to continue into the Valet Mode submenu.
Once entered, the Check Engine Light (CEL) will blink 7 times showing you have entered into the Valet Mode submenu.
Select the Valet Mode status you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer. 0 RPM - Disabled 1000 RPM - Enabled	OR
Using your button configuration, press “enter” to accept the Valet Mode status.	OR

ECU will operate as normal.

Valet Mode will be enabled and the ECU will use parameters set in-app.

When one of the limiters has been exceeded in valet mode, the check engine light is blinking and stays on until valet is turned off.