/
Using Exhaust Flap On-The-Fly

Using Exhaust Flap On-The-Fly

Details about Exhaust Flap On-The-Fly can be found in the main article::Exhaust Flap On-The-Fly

Selecting an Exhaust Flap State

  1. Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly.

    Custom Code Menu details can be found here: Custom Code Menu (CCM)

 

(UniRocker) Short up on rocker
(UniRocker) Short down on rocker

OR

OR

 

  1. Move rocker up and down to navigate through the Custom Code Menu until you reach 6000 RPM (the Burbles submenu).

UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.

 

  1. Using your button configuration, press “enter” to continue into the Burbles submenu.

UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.

 

  1. Once entered, the Check Engine Light (CEL) will blink 6 times showing you have entered into the Exhaust Flap submenu.

 

 

  1. Select the exhaust flap status you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer.

 

0 RPM - OEM

1000 RPM - Closed

2000 RPM - Open

OR

  1. Using your button configuration, press “enter” to accept the exhaust flap status.

 

OR

Sub Menu:

OEM

Exhaust flap will be controlled by the ECU as intended by the manufacturer.

 

 

Closed

Exhaust flap will fully close. However, if the load limiter is exceeded, it will open.

 

 

Open

Exhaust flap will fully open.

 

Related content

Custom Code Menu (CCM)
Custom Code Menu (CCM)
Read with this
Exhaust Flap On-The-Fly
Exhaust Flap On-The-Fly
More like this
Custom Options
Custom Options
Read with this
Using Burbles On-The-Fly
Using Burbles On-The-Fly
More like this
Connection Guide
Connection Guide
Read with this
Using Max Cooling On-The-Fly
Using Max Cooling On-The-Fly
More like this

MG Flasher @ 2025