Using Exhaust Flap On-The-Fly

Details about Exhaust Flap On-The-Fly can be found in the main article::https://mgflasher.atlassian.net/wiki/spaces/MGFLASHER/pages/664830165

Selecting an Exhaust Flap State

Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly. Custom Code Menu details can be found here: https://mgflasher.atlassian.net/wiki/spaces/MGFLASHER/pages/660766721	(UniRocker) Short up on rocker (UniRocker) Short down on rocker OR OR
Move rocker up and down to navigate through the Custom Code Menu until you reach 6000 RPM (the Burbles submenu). UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.
Using your button configuration, press “enter” to continue into the Burbles submenu. UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.
Once entered, the Check Engine Light (CEL) will blink 6 times showing you have entered into the Exhaust Flap submenu.
Select the exhaust flap status you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer. 0 RPM - OEM 1000 RPM - Closed 2000 RPM - Open	OR
Using your button configuration, press “enter” to accept the exhaust flap status.	OR

Exhaust flap will be controlled by the ECU as intended by the manufacturer.

Exhaust flap will fully close. However, if the load limiter is exceeded, it will open.

Exhaust flap will fully open.