[Outdated] Configure Burbles On-The-Fly Before Custom Code v7.1

Details about Burbles On-The-Fly can be found in the main article:

If you have Custom Code v7.1 or newer, see updated instructions here:

 

This article explains how to configure Burbles On-The-Fly for older custom code.

Changing Burbles On-The-Fly:

Using Cruise Control buttons and BC button

  1. Hold the FAR UP button on the rocker switch for 2 seconds to enter burble selection mode.

Rocker located beside RES Button
  1. Check Engine Light (CEL) will flash, blinking at a medium speed, indicating burble selection mode is active.

 

Check Engine Light Medium Blinking
  1. UP and DOWN buttons on the rocker switch will change RPM to reflect burble level.

OR

  1. Select your burble level by pressing the RESUME or BC button (CEL will turn off and state will be updated).

OR

Custom Code v5.4 and earlier

Important notes for Custom Code v5.4 and earlier:

  • CEL will blink twice quickly when enabled and solid when default settings are restored.

  • Drive Mode must be enabled; manual mode deactivates the selection process.

  • You must press the MSA button the required number of times within 2.5 seconds for it to be a valid selection.

  • Engine must be running more than 30 seconds from start

Default Mode – To switch back to your stock/default settings in any Mode (ECU, Comfort, Sport, Sport+) and push the MSA button six times within 2.5 seconds. The Check Engine Light will blink solid as the confirmation.

Level 1 - Switch to ECO Mode via the Driver Experience Switch and push the MSA button four times within 2.5 seconds. The Check Engine Light will blink twice as the confirmation. Then you must return to Sport Mode or Sport Mode+ to hear the changes.

Level 2 - Switch to Comfort Mode via the Driver Experience Switch and push the MSA button four times within 2.5 seconds. The Check Engine Light will blink twice as the confirmation. Then you must return to Sport Mode or Sport Mode+ to hear the changes.

Level 3 - Switch to Sport Mode via the Driver Experience Switch and push the MSA button four times within 2.5 seconds. The Check Engine Light will blink twice as the confirmation. The changes should be heard immediately, given that you are already in Sport Mode, where burbles are active.

Burble OFF - Switch to Sport Mode+ via the Driver Experience Switch and push the MSA button four times within 2.5 seconds. The Check Engine Light will blink twice as the confirmation.

 

MG Flasher @ 2024